分类:
插装阀
压力控制阀
顺序阀
MSQFB
Features
The main stage orifice is protected by a 150 micron stainless steel
screen.
Pressure at port 3 is directly additive to the valve setting at a 1:1
ratio and should not exceed 5000 psi (350 bar)
Intended for use on the actuator side of the system as flow through
the valve must cease for the valve to reset. If used on the pump side
of a system, pump flow must be shut off for the valve to reset.
产品详情
技术参数
·工作压力 350BAR
·流量 120L/min
·额定响应时间 -典型25ms
·内泄漏 工作压力下最大50ml/min
·温度 -30°C至+120°(-22°F至+250°F)
·插孔 见图
·流体 粘度为7.4至420 cSt的矿物基流体
产品特性
·主级的阻尼孔被1 5 0微米的不锈钢滤网保护。
·口3处的压力直接以1:1的比例增加到阀的设定值上,口3处的压力不
能超出5000 psi(350 bar)
·如应用在系统的驱动端侧,通过阀的液流必须停止,阀才能回座。
如果应用在一个系统的泵端侧,泵必须关闭,阀才能回座。
工作
自动跳合顺序阀在进口(口1)压力超过阀设定时全开并保持打开状态,产
生从口1到口2(顺序口)的自由油路。口1压力设定与外泄口(口3)相关。
只要口1压力超过口2压力,阀就会保持打开状态。欲重新设定此类阀,口1
压力必须降至阀的设定值之下,口1至口2的液流必须停止并且口2压力必须
等于或大于口1压力。
